PROTOCOL  FOR  ARTIFICIAL INSEMINATION

USING THE THAWING PLUNGER ASSEMBLY
for improved Artificial Insemination Results

PDF Version 

It must be stated that this Protocol is completely natural and does not incorporate any artificial or chemical additives – (including hormones and stimulants in whatsoever nature.

Please Note: There are NO negative side effects from the utilisation of these products.
  
 

•   Protocol for Thawing Bull / Stallion Semen for the Purposes of Insemination:

•  Prepare water bath as usual – regulate water to desired temperature.

•  Place the Tri-Vortex™ Thawing Plunger Assembly into the water – make sure that water level is very close to, but not above the level of the opening in the Thawing Plunger Assembly.

•  Leave plunger in water for 5 minutes before starting the thawing process.

•  When you are ready and set up, take a straw out of the liquid nitrogen and place it upright into the opening of the Thawing Plunger Assembly (pith side of the straw pointing upwards).

•  When the thawing time has expired, remove the complete Thawing Plunger Assembly from the water bath and wipe off excess water. Place it on the counter or worktop.

•  Leave the straw in the Thawing Plunger Assembly for a further 5-7 minutes or until you are ready to inseminate.

•  When you are ready to inseminate, proceed as per usual.
   
  

•   For the BEST Results and Improved Success with Fertilisation:

•  During breeding season, the cows to be inseminated should wear a
Tri-Vortex™ Bovine Collar around the neck.

It is recommended for the mares to wear/use the various products such as the
Tri-Vortex™ treated blankets and other leather products – please ask for details.

•  These cows/mares should definitely be drinking filtered water that is treated with a 90/180mm Tri-Vortex™ Water Disc.